- The Royal chuck Stop mounts squarely against
chuck face, providing a fixed reference surface for workpieces to locate against.
- allows short parts to project past the chuck
jaws, providing clearance for facing operations.
- eliminates the need to bore soft jaws - greatly
reduces setup time.
- Front and rear locating surfaces are parallel
within +/- 0.01mm (0.0004'').
|
- 24mm slot width is compatible with most 3-jaw
chucks sold in the United States (slots can be milled larger to accommodate chucks with
wider jaws).
- Available in six different thicknesses - 15mm,
20mm, 25mm, 30mm, 35mm, and 40mm.
- Interlocking design coupled with three strong
magnets holds stop securely in place - much safer than using parallels which can be thrown
out by centrifugal force.
- Anodized aluminum finish provides good wear
resistance.
|
