EZ-TRAM
THE FASTEST, MOST ACCURATE WAY TO GET THE HEAD OF YOUR MILL SQUARE TO THE TABLE!

EVERY MILL MAN NEEDS THIS TOOL IN HIS PERSONAL TOOLS!

PROBLEMS SOLVED WITH EZ-TRAM

• TIME LOST SQUARING THE HEAD OF YOUR MILL

• SCAPPED PARTS DUE TO INACCURATE HEAD ALIGNMENT

• TEARING DOWN SET-UP/REMOVING VISE AFER TILTING THE HEAD OR BREAKING AN ENDMILL

• POOR CROSS HATCH PATTERN OR HEALING IN OF FACE MILLS

30  DAY MONEY BACK GUARANTEE
LIFETIME WARRANTY

TESTIMONIALS

FREQUENTLY ASKED QUESTIONS

SPEED AND ACCURACY

We all know that squaring the head on a manual mill can be a difficult and time consuming job. Most machinists avoid it whenever possible. However, after tilting the head OR breaking a tool, this operation is crucial, especially if there is precision work to be done. With EZ-TRAM, perpendicularity of 30 MILLIONTHS per inch is easily achieved and this is done DIRECTLY ABOVE THE WORK (where it should be done) without removing the vise. Simply clean off the mill table. Place the EZ-TRAM over the vise and work set-up*. Attach your indicator to the spindle of the mill and bring the indicator contact tip to the surface of the EZ-TRAM. Zero out the needle and swing the indicator a full 360 degrees to check or align the head. The large gaging surface of the EZ-TRAM is gentle on your indicator and allows rapid movement of your tool.

* large work set-ups may need to be removed.

ABOUT EZ-TRAM

 EZ-TRAM allows the operator to quickly check and align the spindle of a vertical turret mill, perpendicular to the machine table without disturbing the work set-up (in most cases). EZ-TRAM, MINI-TRAM & MICRO-TRAM are made of cast iron and are precision lapped flat to within .000070" over the entire gaging surface and parallel to within .00030" surface to surface. EZ-TRAM has a 15.75" diameter with a 1.8" wide gaging surface, fits over a 6" machine vise with swivel base. MINI-TRAM has a 13" diameter with a 1.75" wide gaging surface and will fit over a 6" machine vise without a swivel base. MICRO-TRAM has a 10" diameter with a 1.6" wide gaging surface and will fit over a 4" machine vise. EZ-TRAM, MINI-TRAM & MICRO-TRAM are shipped in a custom built cardboard container and have a LIFETIME WARRANTY.

MASTER PRODUCT INDEX
HOME