AngLock® D-Series Vises

D675 Shown Above

The original Kurt Anglock D-Series vises are designed for precision part clamping on basic machine tools such as knee-type mills, grinders and machining centers. D-Series vises are ideal for use in running production parts where datums, flatness and parallelism is important. You can precision bore, tap, drill, grind and finish with high accuracy on most parts made of die cast aluminum, steel, and iron in your Kurt Anglock vises. No other brand can give you the time proven accuracy of the Kurt Anglock vises.

All Kurt vises have a friction reducing, needle bearing, thrust collar. The needle bearing increases jaw clamping pressure.

Features:

• AngLock design assures the movable jaw does not lift.
• Hardened vise bed.
• Hardened jaw plates.
• Semi-hard steel screw.
• 80,000-PSI ductile iron body

• Matching of bed height ±.001" available at an additional cost for the D40 and D100 vises.
• Matching of the keyway to the stationary jaw ±.001" is available at additional cost.
• Some models available in metric version.
• 10 year limited warranty.

D40

The D40 vise is recommended for intermediate milling and grinding work. It is an ideal vise for use in matched multiples for holding long parts. With jaw plates in their outside positions, this 4 inch vise has a capacity of 10-5/16 inches.

D675

The D675 has a new vise body with four major improvements:

• Powder coat paint resists peeling.
• Machined rail allows precision alignment.
• A 7-1/2" jaw opening.
• Stationary jaw features an integral key and larger fasteners that reduces deflection by 50%.

Bed height matched to size 2.875" (73.025mm) ±.0005". Patented "O"ring pull down feature is standard. Parts from the previous body style are interchangeable with this new one.

D688™

Features:

• Large 8.8 inch jaw opening.
• Outside rail edges of the body are machined.
• Vise nut does not extend beyond the end of the vise body.
• D688 has the same footprint as the D675 vise. Distance from keyway to stationary same as D675.
• Groove Lock jaw (D60-315) and workstop (WSRL46) standard.
• Patented "O"ring pull down feature standard.
• Approximately a 20% increase in clamping pressure over D675 vise.
• Distinctive patented design of the "Kurt Look".
• Patented AngLock design.
• Bed height matched to size 2.875" (73.025 mm) ±.0005".
• Repeatability within .001".
• Sealed needle thrust bearing used at hex end of screw to reduce clamping friction.

D810

The D810 vise has a big 10 inch jaw opening, the largest in this class. That's a 33% increase in capacity from the D80 vise. The D810 offers greater flexibility in precision part clamping. A very important feature of the D810 vise is its similarity to the D80 vise. If you already have D80 vises in your shop the D810 matches up with the same height and distance of the keyway to the stationary jaw as the D80.

D100

The D100 is the largest and strongest of our general purpose vises. With 9-3/4 inches of jaw opening it has the capacity and strength to take on your highest horsepower milling cuts. It's the most precise and rugged 10 inch production vise in the world.